Controls And Features - Cub Cadet WO STAGE SNOW THROWER 930 SWE Operator's Manual

Controls and Features

Chute
Assembly
Clean-Out Tool
Augers
Snow thrower controls and features are described below and
illustrated in Fig. 4-1.
NOTE: For detailed information on all engine controls, refer to
the separate Briggs & Stratton Engine Operator's Manual.
Shift Lever
The shift lever is located in the right side of the
handle panel and is used to determine ground
speed and direction of travel.
Forward
There are six forward (F) speeds. Position one (1) is
the slowest and position six (6) is the fastest.
Reverse
There are two reverse (R) speeds. One (1) is the
slower and two (2) is the faster.
Headlight
Skid Shoe
Figure 4-1
Drive Control
Shift Lever
Two-Way Chute Control
Auger Control
Wheel Steering
Control
Chute Directional
Control
Choke
Primer
Ignition
Key
Recoil Starter
Handle
Oil Drain
Choke Control
The choke control is found on the top of the engine and is
activated by rotating the knob clockwise. Activating the choke
control closes the choke plate on the carburetor and aids in
starting the engine.
Ignition Key
The ignition key is a safety devise. It must be fully inserted in
order for the engine to start. Remove the ignition key when the
snow thrower is not in use.
Important:
Do not turn the ignition key in an attempt to start
the engine. Doing so may cause it to break.
4
™
Fuel Cap
Oil Fill
Starter
Button
Electric Starter Outlet
11