NRS Healthcare M00789 User Instructions

M00789
General Safety Warning
Please make sure that you read and follow
these instructions carefully. Failure to do so
can result in injury. Keep these instructions in a
safe place for future reference.

1. INTENDED USE

This Shower seat is intended to be used in a bathroom or shower, to provide a stable seated surface for
clients with reduced mobility who are unable to stand during showering. It can be folded up against the
wall when not in use.
Figure 1: Shower Seat (in use)

2. SAFETY

Warning: The maximum user weight must not be
more than 136Kg (21.5st) based on the product
being fi tted to a suitable surface using appropriate
fi xings by a competent person.
It is recommended that this product should only be
installed by a suitably qualifi ed, competent person.
Only install the product in an area where
the mounting surface is structurally sound
(strengthening modifi cations to the fi xing surface
may be required).
DO NOT install in fi breglass/acrylic shower
enclosures with insuffi cient stiff ness and strength.
This product must only be secured to the wall using
fasteners that are appropriate to the structural base
material.
Inspect the product at regular intervals for wear
damage and instability, do not use if you suspect a
fault.
ECONOMY WALL MOUNTED SHOWER SEAT
Economy Wall Mounted Shower Seat
USER INSTRUCTIONS

3. UNPACKING

Remove the packaging and check all parts
carefully. Contact your supplier immediately if
parts are missing or damaged and do not try and
assemble.
Note: Fixings are not supplied with this product.

4. ASSEMBLY/INSTALLATION

Note: You must make sure that the shower base is
level where the seat will be installed.
1. Unfold the seat as shown in Figure 1, then
adjust the legs to the correct height for the user.
2. Using a spirit level, check the seat is fully level.
3. Mark the fi xing positions for the wall mounting
brackets on the wall.
4. Using appropriate, stainless steel screws and
fi xings, secure the brackets to the wall.
5. Check that seat can be raised and lowered
without interference, and that the feet are
securely in contact with the shower base when
lowered.
6. Make sure the seat is fully secure before use.

5. IN USE

Note: Always raise and lower the shower seat using
the seat only, not the legs.
1. Pull the seat down from the wall, making sure
that both legs are level and in contact with the
shower fl oor.
2. Check the seat it is fully secure before sitting
down.
3. Sit centrally on the shower seat.
4. Raise the seat when not in use.
1
Maximum User Weight
21.5st
136kg