Rousseau 2721 Owner's Manual

-Always follow safety recommendations and guidelines provided by the manufacturer of your tools. When in doubt refer to the applicable
owner's manual or other instructions.
-Always make sure all legs are in contact with level ground or floor and legs are extended until locked. Failure to do so could result in saw
movement or the collapse of the table causing injury to the operator and/or equipment.
-Always keep hands clear of hinge, pinch and pivot points. Failure to do so could result in serious injury or loss of fingers.
Be sure saw is bolted securely to the stand. Failure to do so could result in serious injury to self, and/or damage to saw and/or stand.
-Always adjust material supports and rollers to level with the bed of the miter saw. Failure to do so could result in kickbacks, causing serious
injury to self, and/or damage to saw and/or stand.
-Use a hold down or clamp to hold small pieces securely or kickbacks could cause serious injury to self, and/or damage to saw and/or
stand.

WARRANTY

This product has a lifetime warranty to the original purchaser. The warranty applies to defects in materials and workmanship only. We will
repair or replace the product or part(s) at our discretion. This warranty does not apply to product failure or defects due to direct or indirect
misuse, abuse, negligence, accidents, alterations, repairs or lack of maintenance. If items must be returned for warranty service, call to
receive a Return Goods Authorization (RGA) number and further instruction. Freight costs will be borne by the user.

Illustrated Parts Diagram

Owner's Manual
Outfeed Table Support Kit
Model 2721
Fits ONLY
Please read all instructions very carefully.
Bosch Model 4000 & 4100 Table Saws
PARTS INCLUDED (Ref – Qty – Description)
a) 1 – Support Rail
b) 2 – Angle Brackets
c) 2 –10"Adjustable Legs
d) 4 – M6x16 Hex Screw
e) 8 –5/16 Flat Washers

TOOLS NEEDED

-Center Punch -5/16 Drill Bit
-1/8" Allen Wrench -Drill
-10mm Wrench -Pencil
f) 2 – #14x1 Hex Self-Drilling Screws
g) 2 - ¼-20 Tab Base 1/16
Center Pilot Weld Nut
h) 2 – ¼"-20x1/2 Cone Point Set Screws
i) 2 – 1 ½" Square End Caps
j) 2 – Rubber Feet