Table of Contents
Advertisement
Changing from liquid gas to
natural gas
1. Unscrew approximately one turn the
bypass screw position A.
2. Put the knob for the oven functions
back.
3. Connect the appliance to the
electricity.
WARNING!
Put the mains plug into
the mains socket only if
all parts are back into
their initial position.
There is a risk of injury.
4. Light the burner.
Refer to "Oven - Daily use" chapter.
5. Turn the knob for the oven functions
on the minimum position.
6. Remove the knob for the oven
functions again.
7. Screw on slowly the bypass screw till
the flame becomes minimum and
stable.
8. Put the knob for the oven functions
back.
9. Set the maximum gas flow position
on the knob for the oven functions
and let the oven heat for at least 10
minutes.
10. Quickly turn the knob for the oven
functions from maximum to the
minimum gas flow position.
Control the flame. Make sure the flame
does not go out when you turn the knob
to the minimum gas flow position. There
must be a small regular flame on the
oven burner crown. If the flame goes out
adjust the oven burner again.
14.14 Gas grill injector
replacement
1. Release the screws which keep the
grill burner in position A.
2. Release the burner injector with a 7
mm socket spanner and replace it
with a right one.
3. Assemble the burner in a reverse
sequence. Before you fix the screw,
make sure that the burner is pushed
correctly to the back panel.
Test the grill injectors.
14.15 Levelling
CAUTION!
Remove all the accessories
from the oven.
CAUTION!
The assembly should be
made by two people.
1. Open the lid of the appliance and
disassemble it.
2. Disassemble the pan supports and
all the burner assemblies.
ENGLISH
29
A
Advertisement
Table of Contents
