Table of Contents
Advertisement
Lift a side panel into place under the Desk Module and align
2
it with the back panel. (You will need to tilt the panel at an an-
gle to fit it between the pan support rail and the stand cross-
bar.)
Figure 14. Lifting the enclosure side panel into place
Attach the side panel to the bottom of the Desk Module
3
with M4 x 8 mm Philips pan head screws. Leave the screws
loose until you have attached all of the enclosure panels.
Figure 15. Attaching the enclosure side panel to the Desk Module
Place and attach the other side panel to the bottom of the
4
Desk Module in the same manner.
Attach the front panel to the Desk Module with M4 x 8 mm
5
Philips pan head screws. Leave the screws loose until you have
attached all of the enclosure panels.
Figure 16. Attaching the enclosure front panel to the Desk Module
With all four panels in place, attach the panels to each other
6
with M4 x 8 mm Philips pan head screws.
Figure 17. Attaching the enclosure back panel to the side panel
Figure 18. Attaching the enclosure front panel to the side panel
Chapter 2: Installing a Desk Module 7
Advertisement
Table of Contents
