200-299, Memory Test Error Codes - Compaq PROLIANT ML370 Maintenance And Service Manual

3-28 Compaq ProLiant ML370 Maintenance and Service Guide

200-299, Memory Test Error Codes

The 200 series of diagnostic error codes identifies failures with the memory subsystem.
Error Code
200-xx
201-xx
202-xx
203-xx
204-xx
205-xx
206-xx
207-xx
208-xx
209-01
209-02
209-03
209-89
210-xx
211-01
211-02
211-03
211-04
211-05
211-89
214-01
214-89
215
Memory Test Error Codes
Description
Invalid memory configuration.
Memory machine ID test failed.
Memory system ROM checksum
failed.
Memory write/read test failed.
Memory address test failed.
Walking I/O test failed.
Increment pattern test failed
Invalid memory
configuration-check DIMM
installation. DIMMs installed
have 8K refresh.
Invalid memory speed detected -
check DIMM installation. Slow
DIMMs may cause data loss.
RAM long test failed.
Error while saving test block.
Error while restoring test block.
ECC error during testing.
Random pattern test failed.
RAND test failed.
Error while saving test block
Error while restoring test block
Insufficient memory to perform the
test
Failed inverted pattern compare,
but RAM was correct
ECC error during testing
Data error during noise test
ECC error during testing
Non-functioning DC-DC converter
for processor X
Table 3-4
Recommended Action
Reinsert memory modules in correct location and retest.
1. Replace the system ROM and retest.
2. Replace the processor board and retest.
3. Replace the memory expansion board and retest.
1. Replace the memory module and retest.
2. Replace the processor board and retest.
3. Replace the memory expansion board and retest.
Replace DIMMs.
Replace DIMMs with timing greater than 60 ns.
1. Replace the memory module/board and retest.
2. Replace the system board and retest.
3. Replace the memory expansion board and retest.
1. Replace the memory module and retest.
2. Replace the processor board and retest.
3. Replace the memory expansion board and retest.
1. Replace the memory module/board and retest.
2. Replace the system board and retest.
1. Replace the memory module/board and retest.
2. Replace the system board and retest.
Replace the DC-DC converter (Processor Power
Module).