Maintenance; Hinge Adjustment Instruction; Lubrication Procedure - Cleveland SGL-30-T1 Operator's Manual

!
HINGE ADJUSTMENT INSTRUCTIONS
1.
FULLY LIFT COVER
TO RELEASE SPRING
TENSION
SPRING

LUBRICATION PROCEDURE

Lubricate the following parts every three months to
insure smooth operation and reduce wear.
Adjusting
Screw
Worm
Screw and
Tilt
Gear
Cross
excessive play and adjust with adjusting screw located
on top of cross bar.

MAINTENANCE

Any maintenance or service involving disassembly of components
should be made by a qualified service technician. Ensure gas,
electrical and water supply (if applicable) to the unit are shut off.
TRUNNION
HOUSING,
WORM SCREW
AND TILT GEAR
These parts are
accessed through the
top cover of the
Bar
console.
Apply grease to gear
teeth. Check for
WARNING:
2.
USING A
7/16" DEEP
SOCKET
ADJUST LEFT
AND RIGHT
BOLTS
EVENLY
Trunnion Housing
Grease Nipple
19
3.
WHEN PROPERLY
ADJUSTED, COVER
SHOULD REST AT 70˚
TRUNNIONS
On the left hand side of
the skillet there are two
grease nipples on the
top back portion of the
trunnion housing. On the
right hand side of the
kettle you must remove
the console cover to
access the two grease
nipples.