Deceleration Ramp (Without Encoder); Braking Distance (Without Encoder) - Nice M-BOARD Instruction Manual

06 - DECELERATION RAMP (WITHOUT ENCODER)

Enables or disables the deceleration ramp only when not using
encoder sensor.
To enable or disable, place the PROG swith in the position as shown
in the figure below and press the LEARN button according to the
desired setting:
Once selected, return the PROG switch to the OFF position (all
down) for the control panel to save the configuration.

07 - BRAKING DISTANCE (WITHOUT ENCODER)

Adjusts the braking distance (time before reaching deceleration only
when not using encoder sensor.
To adjust, place the PROG switch in the position as shown in the
figure below and press the LEARN button according to the desired
setting:
ON
1 2
LED blinks 1 time
LED blinks 2 times Enable*
ON
1 2
LED blinks 1 time
LED blinks 2 times
LED blinks 3 times
(Table continues on next page...)
DP
3 4 5 6 7 8
Disable
DP
3 4 5 6 7 8
Short
Short average
Average
ENGLISH
73