Learning Course Without Encoder - Nice M-BOARD Instruction Manual

4 - Activate the previously recorded remote control, the control unit
will operate normally only at low speed and without recording path
or torque.
5 - Once the limit switch adjustment is complete, return the PROG
switch to the OFF position (all down).

03 - LEARNING COURSE WITHOUT ENCODER

1 - Check if the gate is engaged. If not, engage it.
2 - After recording the control, make sure the gate is in the middle of
the course or between the limit switches and then press the remote
control.
3 - The center needs to find the opening course end to start learning.
The opening limit switch is the first limit switch triggered during the
course learning process.
4 - After touching the end of the course, the control unit will start
the learning path procedure, which consists of performing a closing
movement.
5 - If the direction of the motor is inverted, it will be necessary to invert
the direction of the motor by placing the PROG switch as shown in
the image below and pressing the LEARN button 1 time.
LED blinks 1 time
LED blinks 5 times
By pressing the LEARN button the LED next to the PROG switch
will flash 5 times indicating that the direction has been successfully
70
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
Reverse direction
Reversed
ENGLISH
DP
7 8
DP
7 8