Learning Course With Encoder - Nice M-BOARD Instruction Manual

changed, then turn the PROG switch to position OFF and continue
the desired settings.

04 - LEARNING COURSE WITH ENCODER

1 - Check if the gate is engaged. If not, engage it.
2 - After recording the control, make sure the gate is in the middle of
the course or between the ends of the course.
3 - Make sure that the stops are installed and very firm, because if the
electronic control unit moves the motor in the wrong direction, when
touching the stop, the control unit will adjust automatically.
4 - The center needs to find the opening course end to start learning.
The opening limit switch is the first limit switch triggered during the
course learning process.
5 - Press the previously recorded remote control, after touching the
end of the course, the control unit will start the learning route proce-
dure, which consists of performing some opening and closing mo-
vements (3 or 4 movements) to perform the parameterization of the
gate parameters .
6 - At the end of learning the route, the gate must be in the fully closed
position, otherwise, it will be necessary to reverse the direction of the
motor by placing the PROG switch as shown in the image below and
pressing the LEARN button 1 time.
LED blinks 1 time
LED blinks 5 times
By pressing the LEARN button the LED next to the PROG switch
will flash 5 times indicating that the direction has been successfully
changed, then turn the PROG switch to position OFF and continue
the desired settings.
ON
1 2 3 4 5 6
Reverse direction
Reversed
ENGLISH
DP
7 8
71