Pump Union 1 - Balboa Clim8zone Installation Manual

26
PLUMBING
ITEMS INCLUDED IN THE BOX
A
Condensation Hose

Pump Union 1

(front view)
Condensation Hose Clamp Gasket 1
D E
Figure 12
Balboa Water Group | Your Single Source Solution
C
B
Pump Union 2
(back view)
Gasket 2 Wrench
F G
Figure 13
A
CLIM8ZONE Unit
TM
Install pump unions
The CLIM8ZONE unit (figure 13,
A) has a cap covering the water
outlet as shown here.
1
Remove the cap as
shown here.
2
Before starting this step,
make sure Gasket 1
(figure 12, E) and Gasket 2
(figure 12, F) are mounted
properly on Pump Union 1
(figure 10, B). Install Pump Union
1 into the water outlet as
shown here.
27
B
Water Outlet
C
Water Inlet
3
Tighten Pump Union 1 with
the wrench (figure 12, G)
as shown here. Wear gloves
to protect your hands from the
edges of the wrench.
Before beginning step 4, make
sure Gasket 2 (figure 12, F) is still
properly seated as shown here.
4
Install Pump Union 2
(figure 12, C) onto the end
of Pump Union 1 as shown here.
5
Repeat steps 1 - 4 for the
water inlet (figure 12, C).
(Continued on next page)
INSTALLATION GUIDE 42391 Rev A
TM