Bosch MIC inteox 7100i User Manual page 78

78 en | Status Codes
Status
Code
12
13**
14**
15
16**
17
2022-01 | 1.13 |
Description
Left and Right Pan Limits have been
set too close to each other.
Autofocus has been turned off
because of excessive focus activity.
Washer operation was attempted
without washer pre-position being
stored.
Attempt was made to move to a pre-
position that is mapped to an
alternate function, so it is no longer
associated with a location.
Motorized zoom function is
programmed to operate at a high
usage level in the Playback Tour.
This high rate of usage could result
in premature wear of the zoom
motor.
Motor operation has been halted
due to an obstruction.
User Manual
Recommended action
(to be completed by a qualified Service
Technician)
position, heat generated by the camera will
help to melt ice buildup from its front
faceplate area.)
3. If the obstruction is from extreme ice
buildup, temporarily avoid operating the
wiper until internal heaters, combined with a
rise in ambient temperature, melt the ice
buildup.
Re-configure one camera stop limit or the
other to increase the distance between limit
stops to at least 10° apart.
1. If practical, increase lighting in the scene
so that the focus function stops "hunting."
2. Use focus in manual mode or One-Push
mode.
Configure the washer pre-position. If
necessary, refer to the subchapter "Using the
Wiper/Washer (Bosch AUX/Pre-position
Commands)" in the User Manual for details
on configuring washer functions.
1. Select/configure a different pre-position
number for the desired location.
2. Re-configure the pre-position assignment
so that this number is no longer associated
with an alternate function. Refer to the
subchapter "Pre-position mapping" in the
User Manual for details on re-mapping pre-
positions.
Re-configure the camera to decrease the
zoom activity to less than 30% during
recording.
1. Remove any obvious materials that are
obstructing operation of the camera pan/tilt
function.
2. If the obstruction is from ice buildup,
review the diagnostic log of the camera
(accessible from the Service menu) for errors
related to the operation of the internal
heaters (and the window defrosters, for MIC
MIC inteox 7100i
Bosch Security Systems