Page 1
S E R V I C E M A N U A L SL-236 Control Box Replacement Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description...
Page 2
Milestone assumes properly assembled and installed using the instructions no responsibility for accuracy, completeness or sufficiency of provided. the information contained in this document. Chief® is a registered trademark of Milestone AV Technologies. All rights reserved. IMPORTANT WARNINGS AND CAUTIONS! WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions.
Page 3
Service Manual REMOVING CONTROL BOX Wiring cover Fully lower SL236, if possible. Turn off and remove power from SL236. Remove projector from SL236 following instructions included with the SL236. Remove signal and power cables from projector. Remove projector cradle by removing four locking nuts (two on each side) and additional washers and spacers.
Page 4
Service Manual Reinstall projector cradle to SL236 lift. (See Figure 3) • Use two nylon spacers (K), two flat washers (D) and two locknuts (G) for rear lift arms. • Use two steel spacers (F), two nylon spacers (K), two flat washers (D) and two locknuts (G) for front lift arms.
Page 8
Europe A Franklinstraat 14, 6003 DK Weert, Netherlands P +31 (0) 495 580 852 F +31 (0) 495 580 845 Chief Manufacturing, a products division Asia Pacific A Office No. 1 on 12/F, Shatin Galleria of Milestone AV Technologies 18-24 Shan Mei Street...
Need help?
Do you have a question about the SL-236 and is the answer not in the manual?
Questions and answers