Remote Control; Emptying The Internal Water Container - Russell Hobbs RHMA 050 Instructions And Warranty

NOTE!
• Remove the 3M™ High Air Flow filter and active carbon filter before seasonal storage and
install new filters at the beginning of the new season. The old filters can be disposed in
the 'Non-biological garbage container'.
• Replacement filter packages are available directly from Amalgamated Appliance (Pty) Ltd.
• To run the unit without active carbon filter and/or 3M™ High Air Flow filter does not do
any harm to the air conditioner. In this case odours and unhealthy dust are not removed
from the circulated air.
• The screen filter must always be used.
• M is a trademark of the M Company.
REMOTE CONTROL
The unit responds to all signals that are sent by the remote control. There
will be a beep sound from the unit after receiving the signal. The operation
of the unit by remote control, is almost identical to the operation by the
control panel. The only exception is the clock function.
Instead of the -button for setting the actual time and for programming
the timer, there are 3 push buttons on the remote control as follows:
• - for setting the actual time.
• TIMER ON - for programming the time when the unit is ON.
• TIMER OFF - for programming the time when the unit is OFF.
EMPTYING THE INTERNAL WATER CONTAINER
Under high humidity conditions it may be necessary to empty the
internal water container. When the internal water container is full
the backlight on the LCD-display flashes. The unit will switch off
automatically.
To empty the water container do the following:
• Switch off the unit and remove the plug from the wall socket.
Do not move the unit. Doing this can result in water leakage,
damaging your floor or carpet.
• Place the water container on the floor underneath the permanent
drainage point.
• Remove the water stopper and rubber plug from the drain and let
the water run out. The water container has to be emptied several
times before all water will be drained (ca. 1.5 litres).
• Replace the rubber plug and water stopper, put the plug into the
wall socket, and switch the unit on. The warning signal should be
off.
NOTE! When the air conditioner is in use, under normal circumstances the condensed water
will evaporate and then be discharged through the hot air outlet hose.
9