CDA 3L9 Manual For Installation, Use And Maintenance page 10

Installation
11. Fit the fixing support cover panel (C) and secure with the
two supplied screws (A), as shown in Fig 19.
12. Fit the extractor top panel, as shown in Fig 20, using the
8 supplied screws (G). Again, ensure that the mains
supply cable is not trapped.
12. Fit the 2 decorative curved panels (M1 and M2) to the
body of the extractor as shown; note these can be
installed offset as shown, or at the same level, as
preferred. Insert the screws (X) into the body leaving
approximately 3mm protruding. Hang the panels onto
the body as shown, finally tightening the screws to secure
the chimney, using a stubby screwdriver or spanner.
A
M
1
M
M
2
Fig. 21
9
2
1
X
2
1 2
X
6
X
A
B
C
A
Fig. 19
X
2/3 mm
X
G
3
Fig. 20