CDA 3Q9 Manual For Installation, Use And Maintenance page 8

Installation
The extractor is mounted using five screws. Ensure that the
wall fixings and screws are suitable for the wall material.
Mark the positions of the five holes on the wall, according
to (fig 6).
Insert five wall plugs into the holes A and B (fig. 7) and fix
four screws into holes A corresponding to the keyholed
positions on the extractor so that they are protruding from
the wall by approximately 5mm.
Next lift the hood onto the screws as shown in figure 7. At
this point the extractor can be aligned level.
Secure the screws and fix the hood into position, using the
fifth screw (B) to prevent any movement.
7
Fig. 6
Fig. 7
83
A A
B
A
211
Fig. 8
467
A
50
650