Table of Contents
Advertisement
Mounting your Extractor
The extractor can be mounted in one of two ways:
1. Mark out the dimensions of the cut-out based on your
hood; the dimensions required are as follows: -
Version
Cut-out Width
CCA5
495
CCA7
695
2. Hold the extractor in the housing and secure to the
canopy using 4 wood screws, located in the corner of
the extractor, as shown as C in figure 3. We
recommend that you seek the help of another individual
when carrying out this task.
3. Connect the exhaust pipe to the duct adapter (B in
figure 2.) and locate on the extractor, as indicated. We
recommend the use of 120mm (5") ducting, although
100mm can be used with the use of a 120-100mm
converter; Note that this will affect performance.
Figure 3 shows how the extractor should be vented: -
Cut-out Depth
257
257
Fig. 3
External Exhaustion
Internal Recirculation
Fig. 4
CANOPY
CANOPY
Advertisement
Table of Contents
