3) Lift the DP connector from the PCB.
4) Place the new component on the PCB. Be sure that it matches the PCB footprint.
5) Solder the new component.
USB-C connector USBC
Repair the USB-C connector:
1) Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
2) Use a hot air gun to melt the solder on the pins
3) Lift the USB-C connector from the PCB.
4) Place the new component on the PCB. Be sure that it matches the PCB footprint.
Solder the new component
RJ45 connector RJ45
Repair the RJ45 connector:
1) Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
20