NW-ZX505/ZX507
2-8.
LITHIUM ION STORAGE BATTERY-1
• Continued on 2-9 (page 32).
Note 1: When wire of the battery assy is removed from MAIN board, insulate
the end of wire by wrap of a tape etc. to prevent short-circuited of the
wire part of the battery assy.
bottom side
front side
4 Remove the solder of
the battery wire [red].
(See Note 1)
31
1 sheet (wire detector)
2 Remove the solder of
the battery wire [white].
(See Note 1)
top side
3 Remove the solder of
the battery wire [black].
(See Note 1)
5 Remove the solder
of the battery sheet.
7 sheet (wire detector)
Attach in order from 1 to 7.
battery assy
1 Press the battery
sheet to the side
of the battery
support.
4 Soldering the battery
wire [black].
lower: [black]
6 Push the HP BTL detect wire
HP BTL detect wire
Note 2: Arrange the HP BTL detect wire so that
it does not overlap the chip parts.
OK
HP BTL detect wire
Sony CONFIDENTIAL
For Authorized Servicer
battery support
2 Soldering the
battery sheet.
MAIN board
top side
3 Soldering the
battery wire [red].
5 Soldering the battery
wire [white].
upper: [white]
in the direction of the arrow.
NG
HP BTL detect wire
SYS SET