Table of Contents
Advertisement
Fastening the Installation Brackets
Each cooktop is provided with an installation kit including brackets and screws for fastening the top to
fixture panels from 2 to 4 cm thick.
– Turn the cooktop upside down and fasten the brackets "F" and "R" to the appropriate socket holes,
without tightening the screws "B" for the moment.
– Make sure that the brackets are fastened as shown in figures 16a, 16b and 16c.
Fastening the Cooktop
– Insert the cooktop into the hole and position it correctly.
– Adjust the position of the brackets "F" and "R" and tighten screws "B" to block the cooktop firmly in
position.
– With a sharp cutter or trimmer knife trim the excess sealing material around the edge of the cooktop.
Take care not to damage the workbench.
R
Fig. 16a
Rear side
B
R
R
F
Fig. 16b
Fig. 16c
F
Front side
B
F
15
Advertisement
Table of Contents
