Mounting And Connecting; Preparations - Siemens Climatix POL8T1.4X/STD Basic Documentation

Check package
contents
Note:
Check operating
conditions
Check clearances
Note:
Make the mounting
cutout
Siemens
Building Technologies
4.

Mounting and connecting

4.1

Preparations

Check the package content for visible signs of transport damage and for
completeness.
Do not install parts damaged during shipment. Contact your Siemens
representative in the event of damaged parts.
Note the information in the following sections of these operating instructions before
installing the Climatix touch panel:
- Climatic ambient conditions
- Protection classes
The following clearances are required around the Climatix touch panel to ensure
sufficient self-ventilation:
Avoid mounting the Climatix touch panel near other devices' AC power cable,
controller output module, relay, or other electrical equipment.
Keep the Climatix touch panel away from equipment such as frequency converters
and power supply units, and shields all input or output cables to the equipment.
The shielding must be properly earth grounded.
Dimensions of the mounting cutout for the Climatix touch panel:
Climatix touch panel
Mounting and connecting
Unit of measurement: mm
x y1
P O L 8 T1 .4 X /S TD 1 0 1 0
P O L 8 T1 .7 X /S TD 1 0 1 0
1 0 1 0
P O L 8 T1 .8 X /S TD
w
P O L 8 T1 .4 X /S TD 1 6 3 mm
2 1 0 mm
P O L 8 T1 .7 X /S TD
3 3 0 mm
P O L 8 T1 .8 X /S TD
A6V10445442
y2 z
7 5 2 5
5 0 2 0
5 0 2 0
h
8 5 mm
1 4 4 mm
2 4 6 mm
13/30
_en--_a
2015-06-30