Table of Contents
Advertisement
Feature
Support for AGDM
Support for AGDM+
10 kHz Signal Sampling
Support for AGMS-D Sensor
Support for AGMS-M Sensor
Support for AGMS-DM+ Sensor
Support for AGMS-D+ Sensor
Support for AGMS-M+ Sensor
Support for Ion Chambers
Support for Dose Diodes
Support for Light Sensor
Support for Current Clamp
Support for Current Sensor
Setting for End of Exposure
Delay
Setting for Trigger Level
Setting for AGMS Calibration
Setting for IC Wave Mode
AGMS Corrections for Dose,
HVL and kV
Ion Chamber Stabilization
Max Exposure Length (with
waveform)
Max Exposure Length (without
waveform)
PrePulse Detection Mode
FreeRun Mode
TimeStamp for Measurement
Dose, Dose Rate, Time Results
for AGMS, IC and DD
AGMS Ave kV, HVL, Filtration
Error Handling and Messages
Records all Sensor Serials
Support for Wave Bandwidth
Filtering
Support for Region of Interest
Handling of legacy IC chambers
AGMS kVp Result
AGMS PPV Result
Max Sensor Rate Results
Min Sensor Rate Results
8
For Nugget firmware 1.0: Max exposure length is 20s – For version 1.4 up to 40s of exposure length with
full wave data are supported. Exposure lengths of more than 40s are supported, but with a limited result
set. 300 sec waveform date/ 2.5 day with out for units with 512 MB memory.
9
Free run supported as of firmware version 1.4.
10
Supported if full resolution wave has been downloaded.
Using Accu-Gold V2 software
USB
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
300 sec
2.5 days
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
Nugget
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
40 sec
8
8
up to 2.5 hours
yes
yes
9
yes
yes
yes
yes
yes
10
yes
10
yes
yes
yes
yes
yes
not planned
89
Advertisement
Table of Contents
