wallas 88 DU Operation Manual

OPERATION GUIDE
P I T H E R M O C O N T R O L P A N E L
Please Refer to Manual for Full Operation and Maintenance Instructions at wallas.com
IGNITION
Press the Power Button for 3 seconds until
the yellow power light will come on. When
you release the button, the yellow heating
light will appear.
Red combustion light will light up when the
burner flame has been ignited and the
combustion has stabilised (approx. in 5 min).
Stove will be fully operational about 10 min
later.
COOKING
Turn the Temperature Knob to max. level
6 and begin cooking. Adjust it to a lower
temperature, if needed, as you would a
domestic stove.
The left plate is hotter and best for boiling, the right
plate is excellent for simmering at a slightly lower
temperature.
HIGH ALTITUDE MODE
When the device is used 1500 m (4,900 ft) above sea
level, it is necessary to activate the High Altitude Mode
to adjust the combustion.
Start the stove by holding the Power
Button down for 10 seconds.
Yellow heating light will flash 3 times and
then change to a solid yellow light. High
Altitude Mode is now on and the stove has
started the ignition process.
All rights reserved. Wallas-Marin reserves the right to change or improve its products and to make changes in the content of this guide
without obligation to notify any person or organization of such changes or improvements. Go to www.wallas.com for current updates and
supplemental information concerning the use of this product.
8 8 D U M a r i n e S t o v e
I
1) Combustion indicator
2) Temperature knob
3) Power button
4) Power indicator
5) Thermostat indicator
6) Thermostat sensor
7) Heating indicator
SHUTDOWN
Press the Power Button down
for 2 seconds. Yellow heating
light will shut off immediately.
I
Red combustion light will
continue to flash for about 5
minutes, while the stove is
cooling down. Unit cannot be
restarted until the cool down is
I
completed.
2 3 7
1
6 4
5
(Not in use in the 88 DU model)
(Not in use in the 88 DU model)
I