Table of Contents
Advertisement
30
Del Zone Eclipse Ozonator
The Del Zone Eclipse ozone generator releases ozone into the spa water.
You will still need to test for chlorine and occasionally replenish it to return
the chlorine level to the baseline.
This plan and its chemical dosages are intended for spas equipped with the
optional Del Zone Eclipse ozonator. The chemical references are designed
for Cal Spas chemicals only.
Start Up
1.
Follow the spa start up procedures for chlorine Clear Water Plan.
2.
Set the spa's filtration time for "F-4". This activates the ozonator and
produces the ozone gas.
Note: Filtration time may need to be increased with heavy bather load.
Day One (Monday)
1.
Test spa water using chlorine test strips. (You will need to use a small amount of chlorine as a supplemental
sanitizer)
2.
Based on the test strip readings:
•
Adjust total alkalinity (acceptable range of 80-120 ppm).
•
Adjust the pH if needed (range is between 7.2 to 7.8).
•
Add 1 tablespoon of chlorine granules.
•
The recommended level of Chlorine is 1-3 ppm.
3.
Add 2 oz of "Stain and Scale Defense".
4.
Remove dirty filter from the spa and rinse off.
5.
Place your extra clean filter cartridge back into the spa.
6.
Vacuum debris from the bottom of your spa with the spa vacuum.
Day Two (Friday)
1.
Test spa water using chlorine test strips.
2.
Based on the test strip reading:
•
Adjust total alkalinity, then the pH if needed.
•
Add 1 tablespoon of chlorine granules (if needed).
3.
Add 2 oz of Cal Spas "Oxidizer Shock" to spa. Run spa for 15 minutes with cover off.
4.
Replace cover.
www.calspas.com
2009 Inground Spas
LTR20091002, Rev. B
Advertisement
Table of Contents
