Table of Contents
Advertisement
34
Cleaning the Cover, Shell and Pillows
Due to the constant punishment your spa cover and pillows receive, you should protect them by applying
Vinyl and Leather Cleaner as part of your monthly maintenance plan. Cal Spas™ Vinyl and Leather Cleaner
is specifically designed to protect spa covers and pillows from chemical and ultraviolet light damage. It ac-
complishes this without leaving an oily residue behind that is normally associated with common automotive
vinyl protectants.
Use of Vinyl and Leather Cleaner
Cal Spas™ Vinyl and Leather Cleaner should be used
sparingly. Incorrect usage may cause water clarity
issues.
Spa Covers
1.
Remove spa cover from spa.
2.
Allow spa cover to dry completely.
3.
Spray Vinyl and Leather Cleaner to cover evenly
and wipe dry.
4.
Allow spa cover to dry completely.
5.
Reinstall cover on spa.
All-Purpose Cleaner (Spa finish
cleaning)
Cal Spas™ All-Purpose Cleaner is an essential part of
maintaining your spa's finish. Through normal use,
the spa's finish can accumulate dirt, oil, and calcium
causing a rough feel and unsightly scum lines. Cal
Spas™ All-Purpose Cleaner is a low detergent, non-
abrasive cleaner specifically formulated to clean the
spa without damaging its acrylic finish.
The most effective solution to minimize cleaning time
is prevention. When the following steps are followed,
the spa's finish will actually start to resist most of
the elements that cause calcium build-up and make
scum line clean up easier.
Prior to Spa Start-Up and Refilling
1.
Spray Cal Spas™ Multi-Purpose Cleaner directly
on to the spa's finish.
2.
Wipe clean with a clean soft cloth.
3.
Repeat on heavily calcified areas.
www.calspas.com
Pillows
1.
Wipe pillows dry with a soft
cloth.
2.
Carefully
spray
Vinyl
Leather Cleaner directly onto
pillow.
3.
Wipe pillows dry.
4.
Allow pillows to dry complete-
ly.
Warning: Do not use automotive vinyl protectants
on spa covers or pillows. These products are gener-
ally oil-based and will cause severe water clarity is-
sues that are difficult to correct.
4.
Wipe spa thoroughly with a wet
sponge, rinsing often with a buck-
et of clean water.
5.
Allow spa to dry completely.
6.
Apply a coat of Cal Spas™ Fast
Sheen to the spa's entire finish
with a soft towel or sponge.
7.
Allow Fast Sheen to dry until white
and powdery.
8.
Buff clean with a soft cloth, rotating frequently.
Periodic Maintenance
1.
Spray Cal Spas™ Multi-Purpose Cleaner directly
to the spa's finish.
2.
Wipe clean with a clean soft cloth.
3.
Wipe spa thoroughly with a wet sponge, rinsing
often in a bucket of clean water.
Cal Spas™ Multi-Purpose Cleaner should not be
sprayed directly into the spa water. Incorrect usage
of this product will cause water clarity issues.
and
2009 Inground Spas
LTR20091002, Rev. B
Advertisement
Table of Contents
