Del Zone Eclipse Ozonator; Maintenance - Cal Spas Inground Series Owner's Manual

2008
Table of Contents

Advertisement

Water Quality Maintenance

Del Zone Eclipse Ozonator

This plan and its chemical dosages are intended for
spas equipped with the Del Zone Eclipse. The chemical
references are designed for Cal Spas chemicals only.
Start Up
1.
Follow the Spa Start Up procedures for Chlorine
"Clear Water Plan".
Set the spa's filtration time for "F-4". This activates
2.
the ozonator and produces the ozone gas. (Follow
the instructions in the owner's manual)
Note: Filtration time may need to be increased with
heavy bather load.
Day One (Monday)
Test spa water using chlorine "Test Strips". (you
1.
will need to use a small amount of chlorine as a
supplemental sanitizer)
2.
Based on the Test Strip readings:
First adjust total alkalinity (acceptable range of
80-120 ppm),
Then adjust the pH if needed. (range is between
7.2 to 7.8)
Add 1 tablespoon of Chlorine Granules.
The recommended level of Chlorine is 1-3
ppm.
3.
Add 2 oz of "Stain and Scale Defense".
Remove dirty filter from the spa and rinse off.
4.
5.
Place your extra clean filter cartridge back into the
spa.
6.
Vacuum debris from the bottom of your spa with the
spa vacuum.
Page 34
Day Two (Friday)
1.
Test spa water using Chlorine Test Strips.
2.
Based on the Test Strip reading:
Adjust total alkalinity, then the pH if needed.
Add 1 tablespoon of Chlorine Granules. (if
needed)
Add 2 oz of Oxidizer Shock to spa. Run Spa for 15
3.
minutes with cover off.
4.
Replace cover.

Maintenance

Regardless of which "Clear Water Plan" you are using,
you should also do the following:
Every Month
Deep clean your spa's filter. (Follow "filter cleaning"
1.
instruction at beginning of "Clear Water Plan")
2.
Check inside the equipment area for leaks, rodents,
and insects.
3.
If a leak is discovered, contact your Cal Spas dealer
for service.
4.
If you see evidence of rodents or insects, take
necessary actions to remove them and precautions
to prevent them from returning.
Every 3 To 4 Months
1.
Drain and clean your spa with "Multi-Purpose
Cleaner".
2.
Polish the acrylic surface with "Fast Sheen".
3.
Clean and treat spa cover, pillows, and Cal Select
cabinet (if equipped) with "Cover Protector".
When re-filling your spa, follow your specific "Clear
4.
Water Plan" Start Up procedures.
5.
If you use the Cal Inline Sanitation System "Clear
Water Plan", don't forget to replace the Mineral and
Bromine Cartridges.
Once A Year
Clean and treat redwood spa cabinets and gazebos with
"Nu-Spa Redwood Stain Renew and Brightner".
Check the filter cartridge pleats. If they are frayed,
replace the cartridge.
2008 Inground Spa Owner's Manual
LTR20081002, Rev. A

Advertisement

Table of Contents
loading

Table of Contents