Handpiece Setup; Handpiece Connection; Air Hose Connection - Pace SX-80 Operation & Maintenance Instructions Manual

SX-80 SX-80
SX-80 SX-80 SX-80

Handpiece Setup

Handpiece Connection

Connect the handpiece connector plug into one of the Power Receptacles on your
PACE power source in the following manner.
1. Align guide on connector with slot on power
receptacle.
2. Insert connector into power receptacle.
3. Turn the connector housing clockwise to
lock in place.

Air Hose Connection

Insure that only one air handpiece is connected to either the Vacuum Port or
Controllable PRESSURE Port at one time.
simultaneously will cause a deterioration of performance.
To set up your SX-80 air hose connection, perform the following steps:
1. Air Hose To Handpiece Connection
a) Attach one end of a 137cm (54 inch) length of air hose to the metal
tube in the back of the handpiece.
b) If you have a PACE system incorporating only one handpiece, attach
the air hose to the SX-80 power cable using the supplied Hose Clamps
(P/N 1321-0085-01). Space them evenly along the length of the power
cable starting at a point 6 inches from the ends of the handpiece.
c) If you have a PACE system incorporating 2 or more air handpieces
(e.g., SX-80, DTP-80, TJ-70, TP-65), you may wish to leave the air hose
assembly unattached to allow a quick change to any air handpiece
being used.
4
NOTE
Attachment to both ports