Table of Contents
Advertisement
6.1 SECURING THE PRINTER MAIN BODY
6.1.1 How to Mount the Printer Main Body
Figure 6-1, Figure 6-2, Figure 6-3 and Figure 6-4 show dimensions for positioning and securing the printer
main body.
• Holes #1 to #3 must be used for positioning the printer main body. Design bosses on the outer case
to position the printer main body for the positioning holes #1 and #2 (LTPD247A / LTPD347A) or #2
and #3 (LTPD247B / LTPD347B). The height of the bosses on the outer case must be 1.5mm (Max.)
• Secure by screw at the U shaped screwing position c.
• Design the fixing hook to the part of a and b.
• The motors of the LTPD247B and the LTPD347B locate at the bottom of the each printer.
In order to avoid interfering with the motor, the FPC and the outer case, secure enough clearance
around the motor shown in Figure 6-2 and Figure 6-4.
CHAPTER 6
OUTER CASE DESIGN GUIDE
6-1
Advertisement
Table of Contents
