Exhaust Hose Installation; Choosing The Right Location; Recommended Installation - Dimplex DCP7W Instruction Manual

Installation

EXHAUST HOSE INSTALLATION

The exhaust hose and adaptor must be installed or removed in accordance with the
usage mode. For COOL, HEAT (heat pump type) or AUTO (on some models) mode
the exhaust hose must be installed. For FAN, DRY or HEAT (electrical heat type) the
exhaust hose should be removed.
EXHAUSTING HOT AIR
In COOL function the appliance must be placed close to a window or opening so the
warm exhaust air can be expelled outside.

CHOOSING THE RIGHT LOCATION

Your installation location should meet the following requirements:
• Make sure that you install your unit on an even surface to minimize noise and
vibration.
• The unit must be installed near a sufficient power outlet, and if using a
continuous drainage method, then the plug areas should be accessible.
• The unit should be located at least 50cm from the nearest wall to ensure proper
air circulation. The horizontal louvre blade should be at least 50cm away from
obstacles.
• The exhaust hose can be extended, however it's best to keep it to the minimum
length required. Ensure the hose doesn't have any sharp bends, sagging areas or
kinks.
• DO NOT cover the Intakes, outlets or remote control signal receptor of the unit,
as this could cause damage to the unit.

RECOMMENDED INSTALLATION

15