Table of Contents
Advertisement
LED Display
Shows the set temperature while on Cool, Heat or Auto mode (on some models).
While on Dry and Fan modes, it shows the room temperature.
Error codes:
E0 - EEPROM error.
E1 - Room temperature sensor error.
E2 - Evaporator temperature sensor error.
E3 - Condenser temperature sensor error (on some models).
E4 - Display panel communication error.
EC - Refrigerant leakage detection malfunction (on some models).
Protection code:
P1 - Bottom tray is full. Connect the drain hose and drain the collected water away.
If protection repeats, call for service.
Note: When one of the above malfunctions occurs, turn off the unit, and check for
any obstructions. Restart the unit, if the malfunction is still present, turn off the unit
and unplug the power cord. Contact the manufacturer or its service agents or a
similar qualified person for service.
Remote Control
1
3
5
7
I SENSE
USING THE REMOTE CONTROL
1. Open the battery cover of the remote control, and
insert 2 x AAA batteries.
2. Please point to the receiver and be within 8m
when using the remote control.
3. If the battery voltage is low, please open the bat-
tery cover as per the diagram and replace with new
batteries ( 2 x AAA). Then replace the battery cover.
(1)
TEMP: Decreases temperature in 1
2
(2)
TEMP: Increases temperature in 1
(3)
ON/OFF: Turns the unit on or off
4
(4)
FAN SPEED: Selects fan speed
(5)
MODE: Scrolls through operation modes
6
(6)
TIMER ON: Sets timer to turn unit on
(7)
LED DISPLAY: Press this to turn on/off the unit
display
C increments
o
C increments
o
13
Advertisement
Table of Contents
