Dimplex DCP7W Instruction Manual page 22

Operating Instructions
COOL operation
· Press the "MODE" button until the "COOL" indicator light comes on.
· Press the ADJUST buttons "+" or "-" to select your desired room temperature. The temperature
can be set within a range of 17°C~30°C/62°F~88°F(or 86°F).
· Press the "FAN SPEED" button to choose the fan speed.
DRY operation
· Press the "MODE" button until the "DRY" indicator light comes on.
· The fan speed or the temperature cannot be adjusted. The fan motor operates at LOW speed.
note: Keep windows and doors closed for the best dehumidifying effect. Do not put the duct to
window.
FAN operation
· Press the "MODE" button until the "FAN " indicator light comes on.
· Press the "FAN SPEED" button on the remote controller to choose the fan speed. The
temperature can not be adjusted.
· Do not put the duct to window.
AUTO operation (on some models)
· When you set the air conditioner in AUTO mode, it will automatically select cooling, heating
(cooling only models without), or fan only operation depending on what temperature you have
selected and the room temperature.
· The air conditioner will control room temperature automatically round the temperature point
set by you.
· Under AUTO mode, you can not select the fan speed.
Note: Under AUTO mode, both the AUTO mode and the actual operation mode indicator lights
illuminate for some models.
HEAT operation (cooling only models without)
· Press the "MODE" button until the "HEAT" indicator light comes on.
· Press the ADJUST buttons "+" or " - " to select your desired room temperature. The
temperature can be set within a range of 17°C~30°C/62°F~88°F (or 86°F).
· Press the "FAN SPEED" button on the remote controller to choose the fan speed.
Wireless operation (on some models)
Used to initiate the wireless connection mode. For the first time to use wireless function, press
the POWER button for 3 seconds to initiate the wireless connection mode . The LED DISPLAY
shows 'AP' to indicate you can set wireless connection. If connection (router) is successful within
8 minutes, the unit will exit wireless connection mode automatically and the wireless indicator
illuminates. If connection is failure within 8 minutes, the unit exits wireless connection mode
automatically. After Wireless connection is successful, for some models you can press MODE
and UP (+) buttons at the same time for 3 seconds to turn off Wireless function and the LED
DISPLAY shows 'OF' for 3 seconds, press MODE button and UP (+) to turn on Wireless function
and the LED DISPLAY shows 'On' for 3 seconds.
Note: When you restart the wireless function, it may take a period of time to connect to the
network automatically.
22