Remote Control; Overheat Protection; Cleaning And Maintenance; Technical Specification - N'oveen HC2100 LCD User Manual

REMOTE CONTROL

Remote control works with Lithium battery CR2025 3V.
12. "Set"
Set real time

OVERHEAT PROTECTION

The heater is protected with an overheat protector that switches off the heater automatically
in case of overheat. e.g. due to the total or partial obstruction of the grids. In this case,
unplug the appliance, wait about 30 minutes for it to cool and remove the object which is
obstructing the grids. Then switch it back on as described above.
NOTE: After switching off, the fan runs for about 30 seconds to cool down the appliance.

CLEANING AND MAINTENANCE

Before undertaking any cleaning or maintenance on the appliance, disconnect it from the
power supply. For cleaning it is recommended to use a soft moist rag and neutral detergent.
Do not use an abrasive cloth or devices which could affect the appearance of the appliance.
Check that the hot air outlet and the ventilation inlet are free of dust and dirt.
During cleaning, be careful not to touch the heating elements.
To open the filter on the back for cleaning, press the top of plastic net at back.
In case of breakdown and/or poor functioning of the appliance, disconnect the appliance
from the power supply and contact an authorised service.

TECHNICAL SPECIFICATION

Power: 2000 W
Voltage: 220-240V~ 50/60 Hz
1. "ON/OFF" Main power button
2. "24H"
Setting timer from 1-24 hours
3. "MODE" 3 settings selection: COLD, WARM, HOT
4. "Swing" Louver swing up and down
5. "LOCK"
Child-Lock function for heater
6. "AUTO"
Window Open Function
7. "Tem."
Display room temperature
8. "Delay"
Set the open and close time of heater
9. "W.Timer" Set the timer of one week
10. "+"
Increase temperature
11. "-"
Decrease temperature
18