Assembly - Close-To-Ceiling Mount; Assembly - Hanging The Fan - HAMPTON BAY ALICANTE Use And Care Manual

Assembly - Close-To-Ceiling Mount

1
Preparing for close-to-ceiling
mounting
□
Remove the canopy ring (L) from the canopy (C) by turning the
ring to the right until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the four screws (SS) on the top of the canopy (C).
□
Remove the two non-slotted screws and loosen the slotted
screws.
□
Remove the decorative canopy bottom cover (N) from the
canopy (C) by depressing the three studs.

Assembly - Hanging the Fan

4
Attaching the fan to the electrical box
WARNING: To reduce the risk of fire, electric shock or personal
injury, mount to outlet box marked "acceptable for fan support
of 35lbs. (15.9 Kg) or less" and use screws provided with the
outlet box.
WARNING: To avoid possible electrical shock, turn the electricity
off at the main fuse box before wiring. If you feel you do not have
enough electrical wiring knowledge or experience, contact a
licensed electrician.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
2
□
□
□
A
SS
C
N
L
□
Install the ceiling mounting bracket (A) on the outlet box (OO) by
sliding the mounting bracket (A) over the two screws (JJ) provided
with the outlet box (OO). If necessary, use leveling washers (not
included) between the mounting bracket (A) and the outlet box
(OO). Note that the flat side of the mounting bracket (A) is toward
the outlet box (OO). When using close-to-ceiling mounting, it is
important that the mounting bracket (A) be level.
□
Securely tighten the two mounting screws (JJ).
8
Routing the wires
Remove three of the six screws and lockwashers (II) (every
other one) securing the motor collar (M) to the top of the fan
motor housing (D).
Route the wires exiting the top of the fan motor assembly (D)
through the rubber gasket (GG), canopy ring (L) and ceiling
canopy (C) (make sure the slot openings are on top); place
the rubber gasket (GG) over the remaining three screws, then
proceed to place the ceiling canopy (C) over the motor collar
(M).
Align the mounting holes with the holes in the motor (D) and
fasten, using the three screws and lockwashers (II) removed
previously. Tighten the mounting screws securely.
II
L
C
GG
M
D