BrewBuilt X1 UNI PRO Assembly And Instruction Manual page 2

GETTING STARTED
This guide will walk you through assembling
and using your new conical fermenter.
READ AND UNDERSTAND
1.
THIS FULL MANUAL
Before your first use, read through this full
manual, and make sure you understand the use &
warnings. Failure to follow these warnings could
result in serious injury or death.
CLEAN THE CONICAL
2.
Before your first use, clean and rinse the conical
along with all the parts and fittings. This
will remove any leftover oil or dust from the
manufacturing process. We recommend using
PBW cleaner. Do not use bleach.
WATER TEST
3.
After cleaning and rinsing, we also recommend
filling your conical with water and familiarizing
yourself with its operations prior to your first use.
First Time Working
With TC Clamps?
Before you tighten down TC clamps, make sure the
gasket is seated properly into both flanges.
Once the gasket is in place, loosen the clamp so it
can be fitted around the flange ends.
You do not need to use any tools for leverage when
tightening TC clamps. Hand tightening is enough for
a secure, leak-proof connection.
WARNING!
ALWAY RELEASE PRESSURE from the fermenter
before removing any TC connection, fitting,
accessory, or lid clamp connected to the Fermenter.
Read section below on how to release pressure
from Fermenter.
PAGE 2 BREWBUILT.COM
Parts List
ITEM DESCRIPTION
A Pressure Lid
B 4" TC Clamp
C 4" TC Gasket
D 1.5" Blow Off Barb
E Silicone Blow Off Tube
F 1.5" TC Clamp
G 1.5" TC Gasket
H Conical Lid
I Lid Clamp
J Lid Gasket
K Conical Body
L 1.5" TC Thermowell
M 1.5" TC Sample Valve
N 2" TC Gasket
O 2" TC Clamp
P 2" Butterfly Valve
Q Flex Chamber
R 3/8" Leveling Foot
Additional Parts
Included:
Neoprene Jacket
1.
Pressure Pack
2.
1
QTY
1
1
1
1
1
3
3
1
1
1
1
1
1
1
1
1
1
4
2