BrewBuilt Flex Chamber Collection Jar Quick Start Manual

The Flex Chamber
Collection Jar
IMPORTANT!
The Flex Chamber Collection Jar is designed for
use with BrewBuilt X3 conicals. Please read these
instructions for important safety information
before using your Flex Chamber. Please also
read the X3 instruction manual that came
with your fermenter and review all warnings
before use. Failure to follow these warnings
could result in serious injury or death.
The Flex Chamber does not have a Pressure Relief Valve and must remain
open to the Fermenter so CO
butterfly valve open while the Flex Chamber is installed. Close valve only
before removing.
PREPARING FOR USE EACH TIME
1. Soak or spray the Flex Chamber Collection Jar and all parts, including caps,
gaskets, clamps, etc., with sanitizer before assembling and attaching it to
your conical dump port.
2. Assemble your Flex Chamber by threading the caps onto the threaded ports.
3. Spray sanitizer into the closed butterfly valve on your conical dump port
as well as the top of the Flex Chamber and its TC gasket. Fasten the Flex
Chamber to the butterfly valve with a 3" TC clamp.
TIP: If you are connecting the Flex Chamber Collection Jar to a full X3 Conical,
it's important to understand some basic displacement concepts. The empty
Flex Chamber is filled with gas (oxygen) that will be sent up through your beer.
If this happens post fermentation it could negatively impact the beer's flavor
via oxidation. See below to learn how to use your Flex Chamber Collection Jar
side ports to flush with CO
can be released. Always keep the bottom
2
.
2