Table of Contents
Advertisement
Quick Links
X1 UNI PRO
ASSEMBLY AND
INSTRUCTION GUIDE
CONTENTS:
PAGE 2–3..............Cleaning, Testing, What's Included
PAGE 3 – 4...............................................................................Assembly
PAGE 5–8............................................................................How to Use
WARNING
Read entire manual for important
safety information before using
your BrewBuilt X1 Uni Conical
Fermenter. Failure to follow warnings
could result in serious injury or death.
BREWBUILT.COM
Advertisement
Table of Contents
Related Manuals for BrewBuilt X1 UNI PRO
Summary of Contents for BrewBuilt X1 UNI PRO
- Page 1 PAGE 2–3....Cleaning, Testing, What’s Included PAGE 3 – 4................Assembly PAGE 5–8................How to Use WARNING Read entire manual for important safety information before using your BrewBuilt X1 Uni Conical Fermenter. Failure to follow warnings could result in serious injury or death. BREWBUILT.COM...
- Page 2 TC clamps. Hand tightening is enough for a secure, leak-proof connection. WARNING! ALWAY RELEASE PRESSURE from the fermenter before removing any TC connection, fitting, accessory, or lid clamp connected to the Fermenter. Read section below on how to release pressure from Fermenter. PAGE 2 BREWBUILT.COM...
-
Page 3: Sample Valve
THERMOWELL Place 1.5" TC Gasket and Thermowell into the open port in front of the conical just below the etched BrewBuilt Logo and fasten in place using 1.5" TC clamp. -
Page 4: Gasket Installation
Incorrect Lid Clamp Assembly: Partial Engagement WARNING Top View WARNING: Improper assembly of the lid clamp can cause the X1 Lid to be ROTATED released while under pressure, possibly CORRECTLY BUT NOT FULLY ENGAGED resulting in injury or death. IN SADDLE PAGE 4 BREWBUILT.COM... - Page 5 USING YOUR X1 PRO CONICAL IMPORTANT SAFETY INFORMATION! Please read this entire instruction manual for important safety information prior to the use of your BrewBuilt X1 Uni Conical Fermenter. Failure to follow these warnings could result in serious injury or death. GENERAL WARNINGS: WARNING: Follow all chemical labeling &...
- Page 6 WITH FLEX CHAMBER is flowing out the bottom. Another option is the included BrewBuilt Flex Chamber that connects to the bottom of the The ability to remove trub and hop sediment is one of the key conical and allows you to collect and dump yeast and trub.
-
Page 7: Installation
The Pressure Pack, specifically designed to work and Pressure Pack lid is rated at 15 psi and the PRV will start with BrewBuilt X1 Conical Unitanks, unlocks many releasing pressure around this point. Never apply more than possibilities. Apply low pressure before cooling 15 PSI to your X1. -
Page 8: Factory Settings
FERMENTING UNDER PRESSURE WARNING: Follow all special warnings and instructions that come with the optional BrewBuilt Pressure Fermentation Kit. DO NOT pressure ferment without using the optional Pressure Fermentation Kit. If you wish to ferment under pressure, or capture CO at the end of fermentation, you must use the optional BrewBuilt Pressure Fermentation Hardware Kit.
Need help?
Do you have a question about the X1 UNI PRO and is the answer not in the manual?
Questions and answers