Advertisement
X1 UNI PRO
ASSEMBLY AND
INSTRUCTION GUIDE
CONTENTS:
PAGE 2-3..............Cleaning, Testing, What's Included
WARNING
Read entire manual for important
safety information before using
your BrewBuilt X1 Uni Conical
Fermenter. Failure to follow warnings
could result in serious injury or death.
BREWBUILT.COM
Advertisement
Table of Contents
Related Manuals for BrewBuilt X1 UNI PRO
Summary of Contents for BrewBuilt X1 UNI PRO
-
Page 1: Table Of Contents
PAGE 5–7...........General Use & Features PAGE 8........Connecting the Control Panel PAGE 8...........Setting Your Temperatures WARNING Read entire manual for important safety information before using your BrewBuilt X1 Uni Conical Fermenter. Failure to follow warnings could result in serious injury or death. BREWBUILT.COM... - Page 2 Before your first use, read through this full manual, Silicone Blow Off Tube and make sure you understand the use & warnings. 1.5" TC Clamp See BrewBuilt YouTube channel for additional 1.5" TC Gasket assembly videos. Conical Lid CLEAN THE CONICAL...
- Page 3 THERMOWELL Place 1.5" TC Gasket and Thermowell into the open port in front of the conical just below the etched BrewBuilt Logo and fasten in place using 1.5" TC clamp.
-
Page 4: Assembly
Incorrect Lid Clamp Assembly: Partial Engagement WARNING Top View Improper assembly of the lid clamp can cause the X1 Lid to be released while ROTATED under pressure, possibly resulting in CORRECTLY BUT injury or death. NOT FULLY ENGAGED IN SADDLE PAGE 4 BREWBUILT.COM... -
Page 5: Important Safety Information
IMPORTANT SAFETY INFORMATION Please read this entire instruction manual for important safety information prior to the use of your BrewBuilt X1 Uni Conical Fermenter. Failure to follow these warnings could result in serious injury or death. GENERAL PRECAUTIONS • Follow all instructions and warnings provided with cleaning agents when cleaning and sanitizing Fermenter. - Page 6 For the ultimate in fermentation temperature control, upgrade The ability to remove trub and hop sediment is one of the key to a BrewBuilt CoolStix & Neoprene jacket along with a BrewBuilt advantages of a conical fermenter. With the butterfly valve open IceMaster Glycol Chiller.
- Page 7 15 psi. Connect your gas-in ball lock QD on your CO draft system that come with the optional BrewBuilt Kit for Fermenting Under to the gas-in body connect located on the Pressure Pack. The gas- Pressure. Do not pressure ferment without using the optional Kit for in body connect has a notch on the side, while the beverage-out Fermenting Under Pressure.
-
Page 8: Connecting The Control Panel
• Do not spray or immerse the control panel. To clean wipe with a damp cloth when unplugged. POWER The BrewBuilt Control Panel has an included InkBird heating and CORD HEATER COOLING cooling controller and a 500 watt 12V DC power supply. It has a tab welded to the top four screws and can be hung on a wall or one of our optional stainless controller stands (CONP735 &...
Need help?
Do you have a question about the X1 UNI PRO and is the answer not in the manual?
Questions and answers