Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Sparco SK300
Summary of Contents for Sparco SK300
- Page 1 CHILD CAR SEAT SK300 Rear-ward facing (40 - 87 cm); Max: 13 kg; 0-18 months INSTRUCTION MANUAL Failure to follow the warnings on the labels and in the instruction manual can result in the death or serious injury of your child.
- Page 2 Notice ! • This is Universal Belted Enhanced Child Restraint System. It is approved according to UN Regulation No.129, for use primarily in,“Universal seating positions” as indicated by vehicle manufacturers in the vehicle user’s manual. If in doubt, consult either the Enhanced Child Restraint System manufacturer or the retailer.
-
Page 3: Table Of Contents
Contents 01 / Warnings ................04 02 / Product overview ............... 06 03 / Suitability ................07 04 / Stature :40-87cm - Installation: Vehicle 3 point belt ... 08 05 / The use of 5-POINT harness system ......09 06 / Adjustment of headrest height ........11 07 / Adjustment of the handle .......... -
Page 4: Warnings
This child restraint system shall be installed and used accordance to this manual. • The child seat shall be away from corrosive corporation. • Make sure that all movable parts of your SK300 are always properly locked in place and that no parts are lodgedbetween movable seats or doors. - Page 5 • Do not leave your child unsupervised in the restraining system, whether harnessed or not. • Children can often be very lively, you should therefore explain to children how important it is to always be safety fastened in. Children must understand that they should never change the way the belts are positioned and never open the buckle.
-
Page 6: Product Overview
PRODUCT OVERVIEW Headrest Shoulder straps hole Shoulder pad Shoulder Straps Buckle Infant Insert Harness release button Harness adjuster strap Awning Handle Lap belt guide Lap belt guide Adjustment button... -
Page 7: Suitability
SUITABILITY • Child car seat should be installed on the back seat. • Do not install on the passenger seat in the front unless the airbag is disabled. • Do not install on the lateral seat. • Do not install on the reverse seat. •... -
Page 8: Stature :40-87Cm - Installation: Vehicle 3 Point Belt
STATURE: 40-87 CM INSTALLATION: VEHICLE 3 POINT BELT １ ３ ２ • Frist Place the baby car seat backward on the car seat and make sure the handle is in its upper position A. • Pull out the vehicle seat belt and place it across the infant carrier. Place the lap belt section in the black belt guides on both sides of the infant carrier.(Fig 1) •... -
Page 9: The Use Of 5-Point Harness System
THE USE OF 5-POINT HARNESS SYSTEM 1. Press release button (7) and pull down the shoulder straps to loosen it (Fig 4). 2. Press the red release button on the strap buckle to separate the shoulder strap from the strap (Fig 5), then place the two inserts and shoulder strap on both sides of the safety seat and place the baby in the seat . - Page 10 THE USE OF 5-POINT HARNESS SYSTEM 1. Guide the two buckle latches together and engage them beforeputting them into the harness buckle (5). This should make a clicking noise. Buckle indicator turn from red to green, that’s locked. 2. Finally, pull down the harness adjustment belt (8) to tighten the five-point safety belt and adjust the shoulder strap to the most fit.
-
Page 11: Adjustment Of Headrest Height
ADJUSTMENT OF HEADREST HEIGHT PULL Press the adjustment button behind the seat with both hands, pull outward and push upward to adjust the headrest height (Fig 6). Note:The headrest must be adjusted so that the shoulder straps are at the same levels as your child’s shoulders on slightly above. -
Page 12: Adjustment Of The Handle
ADJUSTMENT OF THE HANDLE Simultaneously press both buttons on the handle. Then whilst holding the adjustor pressed turn the handle backwards until it engages in the desired position. A: For carrying and for transport in the car. Caution! Ensure that the handle is securely engaged before you pick up the infant carrier. -
Page 13: Fitting The Canopy
HANDLE AND AWNING ADJUSTMENT FITTING THE CANOPY 1.Hook the elastic loops of the canopy from underneath into the hooks on the handle. 2.Pull the elastic loops over the upper edge of the infant carrier. 3.Hang the elastic loops in the hooks under the edge of the infant carrier. -
Page 14: Use Of Cushions
USE OF CUSHIONS Stature:40-75cm(0-10kg) When the child is 0-10kg, the infant insert a&b can be used. The infant insert is removable, and the installation needs to be confirmed if it is installed well. Stature:75-87cm(10-13kg) When the weight of your child more than 10KG, please remove the infant insert and provide more generous space for children. -
Page 15: Care And Storage
CARE AND STORAGE Cleaning: • The cover cannot be removed for washing, special environmental detergent provided by the manufacturer is suggested. • Please use the original cushion and consult dealer or manufacturer for replacement of new cushion. • a) Wash the cushion cover in accordance with the sewn-on care label(inside) •... -
Page 16: Guarantee
GUARANTEE Date of e ect: The guarantee begins on the day of purchase, and within the warranty period of 24 months (with normal use as described on the user manual). Warranty terms: a. The guarantee is valid for the original purchaser only, not transferable. -
Page 17: Original Spare Parts & Accessories
ORIGINAL SPARE PARTS & ACCESSORIES Storing SK300 seat Store the SK300 in a dry place and protect it from dust and direct sunlight. The SK300 original spare parts/the attached information can be obtained directly from the retailer or the manufacture. - Page 18 Produced and distributed under Sparco’s licence by: marketing@carpadesign.net-www.carpadesign.net w w w . s p a r c o - k i d s . c o m...
Need help?
Do you have a question about the SK300 and is the answer not in the manual?
Questions and answers