Page 1
CHILD CAR SEAT SK800I Stature:76-150cm INSTRUCTION MANUAL Failure to follow the warnings on the labels and in the instruction manual can result in the death or serious injury of your child. 202003...
Page 2
Notice ! SK800I Stature:76-150cm i-Size R129 NOTICE This is an i-Size Enhanced Child Restraint System. It is approved according to UN Regulation No. 129, for use in, i-Size compatible vehicle seating positions as indicated by vehicle manufacturers in the vehicle users' manual.
Page 3
Headrest Small headrest Shoulder belt guide Shoulder strap Side impact Shoulder system strap sheath Harness buckle Lap strap Lap belt sheath guide Harness release button ISOFIX Harness adjustment button adjustment Reclination belt adjustment handle Height adjustment handle Top tether Top tether adjustment Top tether fixed hook...
Instructions before installation 1.Child car seat should be installed on the back seat. 2. Do not install on the passenger seat in the front unless the airbag is disabled. 3. Do not install on the reverse seat. 4. Do not install on the additional seat or simple seat. 5.
Page 6
76-105cm ISOFIX + Top Tether I-SIZE ISO/F2X Vehicle 3 point belt I-SIZE Booster Seat 100-135cm Vehicle 3 point belt + SK800I ISOFIX attachment ISO/B2 Vehicle 3 point belt Specific Vehicle 135-150cm Booster Seat Vehicle 3 point belt + ISOFIX attachment...
1. Never use SK800I on a seat, where airbag is activated. 2. The child seat shall be away from corrosive corporation. 3. Make sure that all movable parts of your SK800I are always properly locked in place and that no parts are lodged between movable seats or doors.
Page 8
Safety instructions 13. When the device is used in combination with an adult safety-belt to be used by means of the following word- ing:Only suitable for use in the listed vehicles fitted with 3 point,approved to ECE Regulation No.16 equivalent standards.
2.Pinch the ISOFIX adjustment button(4) on both sides for the ISOFIX adapter(10) to extend on the rear. 3.Place the SK800I in the direction of driving on a vehicle seat or bench seat equipped with ISOFIX mounting bracket. Guide the ISOFIX adapter(10) on the ISOFIX mounting bracket of the vehicle seat and slide the child seat in the direction of the vehicle’s seat...
Page 10
Installation and dismantle of ISOFIX system 1.Pinch the ISOFIX adjustment button(4), pull out to release the ISOFIX adapter(10) 2.Pinch the ISOFIX adjustment button(4) to pull in the ISOFIX adapter(10) when you don’t use it.
NOTE: The child must be secured with the 5-point belt system of the SK800I. The use of the vehicle 3 point belt of the vehicle is NOT permitted. The height adjustment of the backrest must be set to the lowest...
2. Put the child seat on the car seat in drive direction. 3. Adjust the SK800I to the size of your child, make sure the vehicle 3 point belt can go through the guides and can be on your...
Page 13
HANDLE AND AWNING ADJUSTMENT Stature:100-150cm Installation:Vehicle 3 point belt 4.Have your child sit in the safety seat with the back, shoulders, and hips tightly attached.Pull out the car seat belt and make sure that the belt of the car passes under the crotch seat belt guide(3)and the shoulder belt passes over the top of crotch guide (3)and the shoulder belt guide (12).
Installation:Vehicle 3 point belt + ISOFIX attachment Stature:100-150cm Vehicle 3 point belt + ISOFIX attachment 1.Place the SK800I in the direction of driving on a vehicle seat 2.Guide the ISOFIX adapter(10) on the ISOFIX mounting bracket of the vehicle seat and slide the child seat in the direction of the vehicle’s seat backrest until both ISOFIX...
Page 15
Stature:100-150cm Installation:Vehicle 3 point belt + ISOFIX attachment 4.Have your child sit in the safety seat with the back, shoulders, and hips tightly attached.Pull out the car seat belt and make sure that the belt of the car passes under the crotch seat belt guide(3)and the shoulder belt passes over the top of crotch guide (3)and the shoulder belt guide (12).
(17) and simultaneously pulling the shoulder straps. Open the buckle. 2.Place your child onto the seat of SK800I as far as possible. 3.Run the shoulder/lap belts together in front of the child, place the seat belt tongues above each other and...
Page 17
The use of 5-POINT harness system NOTE: The shoulder belt should be situated slightly above the upper edge of shoulder. The shoulder harness should lie in the middle between the neck and the outer edge of the shoulder. The belts of the belt system may NOT be twisted, damaged or...
Removable harness system 1.Press and pull the reclination adjustment handle to position 3. Open the cover of buttom,slide the belt from the locking connector,put the crotch belt at the backside of cover. 2. Remove the belt strape pads . 3. Hide the belt at back of car seat's rest cushion.
Top tether installation 1.Keep the top tether be fastened on the fixed hook tightly to avoid dangerous situation. 2.Take the top tether fixed hook(9) from the seat. 3.Press the top tether adjustment(8) to extend to the length you need. NOTE:Top tether is only suitable for Stature: 76-105cm 4.Guide the top tether (7) straight across the vehicle seat and anchor is using the fixed hook of the anchor point of your...
Angle adjustment Press and pull the Reclination adjustment handle (5), and push the seat into the desired position. There are three reclinations, which can be adjusted to the right position according to the needs of your child. NOTE: Stature:76-105cm can use step 1 to step 3; Stature:100-150cm can only use step 1 to step 2.
Height adjustment 1.Hold the height adjustment handle (6) and adjust the seat height to the size of the child. NOTE: With the adjustment of headrest, the seat will simultaneously adjust the height and meanwhile, the shoulder strap also goes as the child size.
Install and remove side guard 1. Installation: find the installation card slot on the side of the seat, insert the buckle of the side bump block into the card slot, and then push it The side bump block slides forcefully to the right and locks.
The use of small headrest Stature:76-150cm When in stature 76-150cm ,the small headrest must be used. NOTE: stature 76-150cm,the small headrest should be always used.
4.Do not take o the buckle or buckle tongue. 5.The belt can be washed by commercially -available detergent. Storing SK800I Store Galaxy in a dry place and protect it from dust and direct sunlight.
Page 25
Produced and distributed under Sparco’s licence by: marketing@carpadesign.net-www.carpadesign.net w w w . s p a r c o - k i d s . c o m...
Need help?
Do you have a question about the SK800I and is the answer not in the manual?
Questions and answers