Table of Contents
Advertisement
LE910Cx HW User Guide
Recommended Footprint for the Application
Figure 31 and 31-1 shows the recommended footprint for the application board
(dimensions are in mm).
To facilitate the replacement of the LE910Cx module if necessary, it is suggested to
design the application board with a 1.5 mm placement inhibit area around the module.
It is also suggested, as a common rule for an SMT component, to avoid having a
mechanical part of the application board in direct contact with the module.
Note: In the customer application, the region marked as INHIBIT
WIRING in Figure 31 and 31-1 must be clear of signal wiring or
ground polygons.
Figure 31: Recommended Footprint - Top View, 181 pads for LE910Cx variants except for LE910Cx-WWX
1VV0301298 Rev. 33
Page 95 of 128
Not Subject to NDA
2021-06-29
Advertisement
Table of Contents
