Advertisement
EEI-3053 CHAIR
Thank you for purchasing the MODWAY CHAIR.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 20 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all fitting out of reach of children.
Component:
1. Chair Body x1
Customer Service 908-368-1025︱www.modwayfurniture.com
4
1
2
2 Base x 1
3 Seat Cushion x 1
Hardware:
A.
B.
C.
D.
E.
3
4 Back Cushion x 1
Bolt 1/4"x25mm
x 4
Flat Washer
x 4
Allen Wrench
x1
Cover
x 4
Foot Pad
x 4
Page 1 of 3
Advertisement
Table of Contents
Related Manuals for modway EEI-3053
Summary of Contents for modway EEI-3053
- Page 1 EEI-3053 CHAIR Thank you for purchasing the MODWAY CHAIR. Before you start, here are some helpful advice: 1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions. 2. Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
- Page 2 EEI-3053 CHAIR STEP 1: Please put Chair Body (1) on a carpeted or padded surface. Attach Base (2) to the bottom of Chair Body (1) by using 4 pieces of Bolts (A) with 4 pieces of Flat Washers (B) as shown. Tighten Bolts (A) by using Allen Wrench (C) as shown.
- Page 3 EEI-3053 CHAIR STEP 3: Carefully turn over the assembled Chair Body (1) and Base (2) from step 2 as shown. STEP 4: Attach Seat Cushion (3) to the bottom of Chair Body (1). Attach Back Cushion (4) to the top of Seat Cushion (3).
Need help?
Do you have a question about the EEI-3053 and is the answer not in the manual?
Questions and answers