Advertisement
Quick Links
EEI –537
CHAIR
Thank you for purchasing the MODWAY CHAIR!
Before you start, here is some helpful advice:
1.
We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.
Owing to the size and weight of the dining chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.
Please do not use any tools other than those provided or recommended in these instructions.
4.
Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.
Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.
Please keep all pieces out of reach of children.
Component:
1
Chair Body
x1
Customer Service 908-368-1025︱www.modwayfurniture.com
Hardware:
A
B
C
D
E
F
G
H
1
2
3
2
Chair Leg
Medium Bolt M6x27mm
Short Bolt M6x20mm
Long Bolt M6x35 mm
Nut M6
Metal Support
Allen Wrench M4
Plastic Washer
Door Mat
3
x1
Chair Leg
x 4
x 1
x 4
x 5
x 2
x 1
x 4
x 4
x1
Page 1 of 4
Advertisement
Related Manuals for modway EEI-537
Summary of Contents for modway EEI-537
- Page 1 EEI –537 CHAIR Thank you for purchasing the MODWAY CHAIR! Before you start, here is some helpful advice: We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions. Owing to the size and weight of the dining chair, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
- Page 2 EEI –537 CHAIR STEP 1: Insert 2 pieces of Plastic Washer (G) into the end of Chair Leg (2) as shown. Move the Plastic Washer (G) on the right Position, and make sure the holes on Plastic Washer (G) align to the holes on Chair Leg (2). Repeat the same step for the remaining Chair Leg (3).
- Page 3 EEI –537 CHAIR STEP 1: Please put Chair Legs (2&3) upside down on a carpeted or padded area. Place Chair Leg (3) to the bottom of Chair Leg (2) as shown. Insert 1 piece of Short Bolt (C) through the holes on Chair Leg (3) into Chair Leg (2) as shown. Secure 1 piece of Nut (D) into Short Bolt (B) by hand.
- Page 4 EEI –537 CHAIR STEP 3: Place the assembled Chair Legs (2&3) to the bottom of Chair Body (1) as shown. Attach by using 4 pieces of Long Bolt (C) as shown. Use Allen Wrench (F) to tighten Long Bolts (C) clockwise until secure. Hardware &...
Need help?
Do you have a question about the EEI-537 and is the answer not in the manual?
Questions and answers