Cardinal 225D Instructions Manual page 6

6. Click on the Reset button in the AVR program. A message will be displayed at the bottom left
of the AVR screen in the Status Box indicating the condition of the connection. See Figure 7.
•
RED light indicates a problem with the connection.
•
GREEN light indicates a good read along with the processor detected.
NOTE: The correct processor for a 225D will be "Detected device: ATmega2560".
Page 6
8200-0820-0M Rev A • 225D Firmware Update Instructions
Device shown must match device
detected in Status Box
IE: ATmega2560
Red light indicates no connection with processor
Green light indicates a good read
Device detected is displayed IE: ATmega2560
Status Box
Figure 7