Cardinal 225D Instructions Manual page 17

17. When programming is complete, the Status Box located at the bottom of the AVR screen will
display a confirmation message "Auto Program Complete" along with a GREEN light. See
Figure 19.
If an error occurs during programming a RED light will be displayed along with an error in the
Status Box. If this occurs, first confirm that all settings are correct, save a copy of the EPROM
from AVR to your hard drive, go to Auto Program options and remove the check next to Read
EEPROM, and try to program again.
IMPORTANT: Indicator setup and calibration data are stored in the EEPROM.
If the EEPROM file is lost or corrupted the indicator will require setup and calibration.
18. The update of the 225D indicator is now complete.
19. Disconnect the dongle from the circuit board and confirm the indicator operation.
8200-0820-0M Rev A • 225D Firmware Update Instructions
Figure 19
Page 17