Table of Contents
Advertisement
a D:GROUP Company
UV PROGRAMMING:
-
use "UP/DOWN arrow" keys [8] to scroll the operator menu
-
select "UV PROGRAMMING" press "SET" [10]; and the display shows:
-
input the desired time for the UV cycle and press SET [10] to confirm
-
the display shows:
-
set date and time with the arrow keys and confirm pressing SET. when the time previously set is
reached the UV lamp switches ON, if the requirements to switch ON the UV lamp are not satisfied
(e.g.: glass open) an alarm message will be displayed.
-
press "ESC" [9] to exit the operator menu.
U.V. LAMP RESIDUAL LIFETIME:
-
use "UP/DOWN arrow" keys [8] to scroll the operator menu
-
select "U.V. LAMP RESIDUAL LIFETIME." and press "SET" [10] key; the display will show:
-
where XXXX shows the number of the hours set for lifetime of the U.V. lamp.
-
Use the "up and down arrow" keys to adjust the hours parameter
-
Then press the "SET" key [10] to confirm the data and/or go back to previous menu
-
To conclude programming, press ESC" [9] key.
FILTERS RESIDUAL LIFETIME:
-
use "UP/DOWN arrow" keys [8] to scroll the operator menu
-
select "FILTERS RESIDUAL LIFETIME." and press "SET" [10] key; the display will show:
where XXXX shows the number of the hours set for lifetime of the FILTER 1
-
Use the "up and down arrow" keys to adjust the hours parameter
-
Then press the "SET" key [10] to confirm the data and pass to filter 2 and so on up to filter 5
-
To conclude programming, press ESC" [9] key.
00055EN Rev.10 – 12/2011
UV LIGHTING LENGTH
SET UP
hh:mm
.UV PROGRAMMING
DATE & TIME
U.V. LAMP RESIDUAL LIFETIME
set XXXX
FILTER 1 RESIDUAL LIFETIME
set XXXX
16
Advertisement
Table of Contents
