Troubleshooting - Hitachi PV-XL300J Instruction Manual

Troubleshooting

The vacuum cleaner does not operate, or stops while the vacuum cleaner is running. The suction power is weak. The rotary brush does not rotate.
The safeguard might be operating. Release the safeguard with the following instructions.
Suction power of the vacuum cleaner becomes
weak or stops while the vacuum cleaner is running.
To prevent the vacuum motor or the battery from overheating,
the vacuum cleaner might sometimes automatically enter safe
mode, in which the vacuum cleaner runs with less electricity
and reduced suction power.
The filter indicator is
blinking (about once
per second).
Dust clogged
in clean filter
or sponge
filter
Go to 1
Press the
1
Empty the dust
case or maintain
the dust case or
filters.
(P.E-16 to E-22)
The safeguard is released after 5 to 60 minutes,
PV-XL300J_EN.indd 25 PV-XL300J_EN.indd 25
The battery indicator is
blinking slowly (about
once every 4 seconds).
Operation The battery The vacuum
while is hot. cleaner
blocking motor is hot.
the inlet
Go to 2 Go to 3 Go to 3
button of the vacuum cleaner to stop operation.
2
Remove the
object that is
blocking the
inlet.
and you can use the cleaner as usual.
Before requesting for repair
Check the following points again.
The rotary brush of the power head stops.
If the vacuum cleaner is continuously operated in a state
where there is a lot of resistance to the rotary brush, the
rotation of the rotary brush stops automatically to prevent
the motor from overheating.
Foreign
matter stuck
Go to 4
3
Let the vacuum Remove the
cleaner cool down. foreign
(It might take some substance from
time before the the rotary brush.
vacuum cleaner
cools down.) (P.E-23, E-24)
Power head
pressed against
floor or carpet
Go to 5
4 5
Do not press the
power head
against the floor
or carpet.
E-25
2021/9/22 11:11:05 2021/9/22 11:11:05