Table of Contents
Advertisement
Emptying the dust case and cleaning the fi lters
Cleaning the fi lters
Clean fi lter
Open the clean fi lter.
1
Set the dust case on the
fl oor.
Remove dust and debris from the clean fi lter
2
Detach the clean fi lter.
Sponge
filter
Wash the sponge filter
with water if there is dirt
on the filter.
Note
Be sure to attach the sponge
filter after emptying the dust
case or cleaning the filters.
Attach the clean fi lter.
3
Attach the clean fi lter in the reverse order of
removal.
Close the clean fi lter.
4
Press fi rmly until you hear a "click" sound.
Note
Make sure the sponge fi lter
is attached.
E-18
PV-XL300J_EN.indd 18
PV-XL300J_EN.indd 18
Dust case
Clean filter
(P.E-21)
Perform maintenance (wash with water) when you are concerned about dirt or the
suction power is weak. (P.E-21)
Clean filter
Grab and hold the lower part of the dust case, lift up the knobs of the
clean fi lter, and open the cover in the direction indicated by the arrow.
Knobs
Detach
Note
When removing dust and debris, do not slap the clean fi lter
onto the fl oor, etc. Failure to do so might cause damage.
To clean the clean fi lter, use the maintenance brush that
was provided with the vacuum cleaner.
Clean filter
(continued)
Clean filter
Remove attached dust and debris
by using the maintenance brush.
Maintenance brush
Attach
Click
2021/9/22 11:11:04
2021/9/22 11:11:04
Advertisement
Table of Contents
