Simplicity BRIO CANISTER Owner's Manual page 6

WARNING
Operators must be fully trained in the use of the machine in accordance with
these instructions, able to perform user maintenance and the correct selection of
accessories.
Operators should be physically capable to maneuver, transport and operate the
machine.
• Operators should be able to recognize unusual operation of the machine and report
any problems.
• Only use the machine on firm level surfaces.
• Wear suitable footwear to avoid slipping.
• Wear suitable clothing to keep dry and warm.
• Where possible implement job rotation and adequate rest periods to avoid
continuous use of the same muscles.
• Do not leave machine running unattended.
• Do not smoke when using the machine.
CAUTION - This machine is for indoor dry use only and should not be used or stored
outdoors or in wet conditions.
CAUTION - If it is suspected that there is hazardous dust or flammable materials stop
cleaning the area immediately and consult your superior.
WARNING Only use accessories and spare parts provided with the machine or those
approved by the manufacturer. The use of other accessories may impair the safety of
the machine.
• Ensure the machine is switched off before adding or changing accessories
Transporting the machine
CAUTION – Incorrect lifting techniques may result in personal injury, where applicable
do not lift large and heavy machines without assistance. We advise that the manual
handling regulations are followed.
When transporting the machine, ensure that all components, tanks and removable
parts are securely fastened, and that the supply cord and plug are not trailing. Detach
hose and wand from machine where applicable.
Take extreme care when moving the machine up or down steps or stairs.
Preparing for use
Electrical connection
Before connecting the machine to the power supply, check that your supply voltage
corresponds with that marked on the rating label.
The power supply cord plus any extension leads should not exceed 100 ft. (30 m) in
total, otherwise you may experience problems starting up the machine. The cross-
section of any extension cable wiring must be at least AWG 13 (2,5 mm
Should an extension cord be used, ensure cord rating is adequate for the equipment.
Do not use extension cord in coiled condition as this could result in overheating of
the cord.
IMPORTANT - If the supply cord is damaged, it must only be replaced by a special
cord available from the manufacturer or an authorized service agent.
5
GUIDELINES FOR THE OPERATOR
).
2