Summary of Contents for Dreamline AQUA-Q FOLD SD-363072Q Series
Page 1
® purpose of product improvement and customer experience. Please refer to the model’s web page on DreamLine.com for the latest technical drawings, installation manuals, warranty information or additional product details. left-pivot door installation shown...
Page 2
NSTRUCTIONS IMPORTANT DreamLine® reserves the right to alter, modify or redesign products at any time without prior notice for the purpose of product improvement and customer experience. Please refer to the model’s web page on DreamLine.com for the latest technical drawings, installation manuals, warranty information or additional product details.
Page 3
3. Shower bases must be installed by a licensed plumber. Please note that you should consult your local building codes with questions on installation compliance standards. Building and plumbing codes may vary by location and DreamLine ® is not responsible for code compliance standards for your project.
Page 20
To maximize the life of your door, it is important to regularly inspect the glass and other hardware for misalignment, proper attachment, and/or damage. Contact DreamLine with any questions or concerns. SLIMLINE SHOWER BASE manual Ver 5 Rev 9a 11/2018...
Page 23
Record the following purchase information for your records or in the event you need to contact DreamLine ® Purchase Order Store/Vendor Number Purchased From OD Number Installation Date (optional) located on the shipping box or label if available. SKU Number...
Table of Contents Section Title Page # Warnings and General Preparation Model Specific Preparation Adjustable Wall Profile System Tools Detailed Diagram of Aqua-Q Swing Shower Door Components Parts List Installation Steps 9-17 Glass-to-Glass Hinge Assembly Installation 11, 18 Vinyl Seals Installation Aluminum Threshold Dam Strip Installation Knob Handle Installation Product Maintenance...
Page 25
IMPORTANT GENERAL PREPARATION • DreamLine® reserves the right to alter, modify or redesign products any time without • After opening all boxes and packages, read this introduction carefully. Check that all the prior notice for product improvement and customer experience. Please refer to the items are included in the package by marking off the components on the “Detailed...
Model Specific Preparation REQUIRED: 1-1/2” minimum ±0.0 ±0.0 threshold Installation wall must be plumb 1-1/2” (37.5mm) minimum 1/2” (12mm) threshold Out-of-Plumb Adjustment within the Wall Profile; Verify threshold and walls with a level Threshold must be level ±0.0 DO NOT attach the Handle to the Door Glass until instructed.
Adjustable Wall Profile System Wall Profile Glass The Glass Profiles can be adjusted up to Profile 1/2” within the Wall Profile for overall width or to correct for out-of-plumb conditions within the model size. Screw Vinyl them together after making final Insert adjustments.
Before discarding the carton, check for small hardware bags that may have fallen to the bottom of the box. If any NOTE parts are damaged or missing, please contact DreamLine for replacement. The shipping ®...
Page 29
Detailed Diagram of AQUA-Q FOLD Shower Door Components inside AQUA-Q FOLD Shower and Tub Door Manual Ver 1 112020...
Installation Steps Check the walls and threshold for plumb and level. This model allows for up NOTE to 1/2” of out-of-plumb adjustment per wall. The threshold must be level for correct installation. Fig 1 Parts Needed Center the Wall Profile (#01) on the Threshold. NOTE Tools Needed Confirm the Wall Profile (#01) is plumb with a level...
Page 33
*see NOTE *see NOTE silicone the back of the Wall Profile Install the Wall Profiles (#03) Fig 2 NOTE so that the holes face towards the inside of the shower. ◾If a Stud is present behind the wall: NOTE drill a Ø3/16”(4mm) hole up to the stud, drill an Ø1/8”...
Glass-to-Glass Hinge Assembly Installation Secure the Door Glass 1 (Pivot Profile) (#02) and Door Glass 2 (#03) with the Hinge Assembly (#04) before install it into the Wall Profile (#01) Maintain even spacing between the door glass during the hinge installation. NOTE outside outside...
Page 35
1/2” (12mm) Fig 4 Place 1/2” (12mm) thick wood or plastic shims onto the threshold to provide proper spacing beneath the door glass. 1/2” (12mm) Make any final adjustments to the door so that it is level and plumb in the opening. AQUA-Q FOLD Shower and Tub Door Manual Ver 1 112020...
Page 36
Decorative Caps Installation After final adjustments, drill Ø1/8” holes through the pre-drilled holes located in the ID groove in the Wall Profile (#01). Drill only through the first layer of the Glass Profile NOTE and install the ST4.0x10mm Pan Head Screws (#07) using the Decorative Covers and Washers (#08) Fig 5 Ø1/8”...
Vinyl Seals Installation Measure from inside top of door to top of hinge Measure Attach the Vertical Vinyl Seal (#12) between to the inside edge of the Door Glass the two (#03) that is on the same side as the hinges shower head so that the flexible fin is pointing away from the water source.
Page 38
Threshold Installation Open the Door Glass and install the Threshold Dam Strip. NOTE inside inside Fig 7 This product is shipped with both a left and right Dam Strip Clip installation. The large curved lip of the dam strip is intended to face toward the outside of the shower NOTE to ensure the flow of water is redirected towards the drain.
Knob Handle Installation Install the Knob Handle (#10) through the pre-drilled holes on the NOTE Door Glass (#01). Be sure to use all of the included gaskets and sleeves to prevent glass-to-metal contact. Fig 8 Parts Needed Extra gaskets are supplied with the Knob Handle (#10) to be used to align the inside and outside knobs with one NOTE another if necessary.
Page 40
The surfaces need to be clean and free of debris before applying silicone NOTE Apply silicone to the wall and threshold, along the inside edge of NOTE the wall profile and threshold. Fig 9 Tools Needed Allow 24 hours for the silicone to cure before using the shower AQUA-Q FOLD Shower and Tub Door Manual Ver 1 112020...
To maximize the life of your door, it is important to regularly inspect the glass and other hardware for misalignment, proper attachment, NOTE and/or damage. Contact DreamLine with any questions or concerns. ® AQUA-Q Fold Maintenance Checklist ◻...
Page(s) • Check all shipping/packaging material for missing parts/components. Missing Parts • If not found, contact DreamLine Customer Support [1-866-731-2244] to order factory part replacement. • Check the Vinyl Seals for proper trimming and installation • Confirm the Hinge Assemblies are tightly secured to the Door Glass.
04 = Brushed Nickel 06 = Oil Rubbed Bronze 09 = Satin Black Contact Support@DreamLine.com for Part replacement, installation assistance or additional information. Complete Warranty information is available on DreamLine.com. AQUA-Q FOLD Shower and Tub Door Manual Ver 1 112020...
Page 44
04 = Brushed Nickel 06 = Oil Rubbed Bronze 09 = Satin Black Contact Support@DreamLine.com for Part replacement, installation assistance or additional information. Complete Warranty information is available on DreamLine.com. AQUA-Q FOLD Shower and Tub Door Manual Ver 1 112020...
Page 45
04 = Brushed Nickel 06 = Oil Rubbed Bronze 09 = Satin Black Contact Support@DreamLine.com for Part replacement, installation assistance or additional information. Complete Warranty information is available on DreamLine.com. AQUA-Q FOLD Shower and Tub Door Manual Ver 1 112020...
Page 49
TEL: 866-731-2244 FAX: 866-857-3638 DREAMLINE.COM For more information on DreamLine Shower Doors and Enclosures please visit DreamLine.com ® AQUA-Q FOLD Shower and Tub Door Manual Ver 1 112020...
Need help?
Do you have a question about the AQUA-Q FOLD SD-363072Q Series and is the answer not in the manual?
Questions and answers