Table of Contents
Advertisement
Time Required for Process Control
The customer may ask why the machine stops
for a significant time.
Initial start-up
» Process control: approx. 30 seconds
During a job
» Process control: approx 30 seconds
At the end of a job
» Full color Job end Process control: approx. 11 seconds
» B&W Job end Process control: approx. 6 seconds
Slide 176
For 1200 dpi/OHP/Thick paper mode, it is always approx 30 seconds.
Toner adjustment mode can add anything up to an extra minute, depending on
the conditions.
Comparison with AT-C1:
For process control that is done just after a print job, note that the time is
reduced to 11 seconds (for full color) or 6 seconds (for black-and-white jobs). For
the AT-C1 it was always 20 seconds.
Why is it quicker? The sensor pattern is made while the last page of the job is
still feeding out of the machine. In the AT-C1, the machine waits until the paper
is completely fed out before the patterns are made. Also, for black and white, the
Di-C1/Di-C1.5 only make the black sensor pattern.
176
Di-C1.5 Training
Advertisement
Table of Contents
